NM100: PIC In Circuit Programmer


This is NorthMicro’s low cost development class In Circuit Programmer. It connects to a computer running Microchip’s MPLAB IDE software using a serial cable. The programmer responds to MPLAB as if it was a PICSTART PLUS. It is designed to be used with Northmicro’s NM101 prototype board, (or use it with your own target board by supplying the 5 wire ICP interface). This combination gives the user a unique environment in which code can be developed and tested on the target system without removing the microcontroller. This reduces the chance of broken pins and speeds development.

$99.00
Includes a NM101 Pic Proto Board
and an NM101C Stackable Connector!

MPLAB allows users to seamlessly program in C from various venders, or PIC assembly. The target can then be programmed without ever leaving the design environment, eliminating potential problems of programming with the wrong version of code.

The programmer makes use of Microchip’s PIC incircuit programming capability allowing the user the freedom of never having to remove the microcontroller during the programming phase.

It is fully compatible with MPLAB. This software is available for download from Microchip website. www.microchip.com

The programmer does not need any special power supplies. It derives all its needs from a 5Volt supply from the target system.

No additional software or patches are required.

System operates at 20MHz for accurate timing.

Capabilities:

Operates with MPLAB running on a windows environment

Reads, programs, verifies EPROM and EEPROM program and data memory

Reads, programs, verifies all configuration bits

Programs and verifies an address range

Displays, edits, and transfers device contents to and from programmer unit.

[ back to products ]